Wholesale Distributors for Serrated Gasket for Cambodia Manufacturer

1.Structure

Serrated Gasket is made of machined flat metallic plate with waved or corrugated surface in 90 degree angle.

The Serrated Gasket with inner and outer rings or composite gasket attached with flexible graphite or Teflon sheet are available depending on the working location and requirement.

2.Characteristic

Serrated Gasket is an idea gasket used in low pre-tightening, the soft sealing surface avoid metal to metal touch, can be combined reliably and closely, protect flange not to be damaged. This kind of gasket is suitable to high pressure and high temperature location. Strong corrosion resistance, stable and reliable sealing function.

3.Gasket Typ

   Basic Type                                        With outer Ring

4. Working Environment

Working Temperature：~650℃

Working Pressure：6.4-16.0MP

Min. Pre-tightening：y=70MPa

Re-install the drive shaft and jet pump.

Clean threads inside the bolt holes in the pump base and clean the bolt threads.

Grease the splines on both ends of the drive shaft, and the O-ring seal that fits into the impeller.

Make sure the pump section fully seats aginst the pump base, and the drive shaft fully engages the PTO drive coupler.

As you tighten the bolts, check that the nozzle assembly is square and level, not tilted. Snug the bolts, check for proper pump assembly.

Then torque to 18 ft-lbs in a criss-cross pattern.