13 Years Manufacturer Spiral Wound Gasket-RIR for Manchester Factory
13 Years Manufacturer Spiral Wound Gasket-RIR for Manchester Factory Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
O-Ring Sizes for Industrial Applications
A Look at the Molded Gasket
13 Years Manufacturer Spiral Wound Gasket-RIR for Manchester Factory, The product will supply to all over the world, such as: , , ,
Gaskets-to-Go is a custom gasket manufacturer. In addition to the quality of our work, what distinguishes us from other custom gasket makers is that there are NO TOOLING or SET-UP charges and NO MINIMUM ORDER SIZE for most gaskets. Please view this short video to see what we can do, or visit our web site at www.gasketstogo.com to learn more. You can also write us at inquiries@gasketstogo.com
Application of sealing materials is done in order to prevent water leakage into cavities of the car body, and to reduce noise. The complexity of the sealing spray process is characterized by multi-phase and free surface flows, multi-scale phenomena, and large moving geometries, which poses great challenges for mathematical modeling and simulation. Also, the sealing material is strongly shear thinning implying that the viscosity depends on the shear rate.
The software IPS Virtual Paint – Sealing is developed by Fraunhofer-Chalmers Centre and provides the industry with a feasible tool to predict the shape and process of robotized sealing application.
By from -
By from -
