Factory Wholesale PriceList for Spiral Wound Gasket-RIR to Denver Manufacturers

Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.

Feature

Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.

Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface

Easy installation and handy use.

Excellent Sealability

Products Type

Technical Data Sheet

 Application Area

The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.

hydraulic compactor main for cardboard
with high pressure power
voltage can be design by require
with CE certificate
The basic principle of horizontal hydraulic metal baler that is the use of metallic materials in the external force, to the nature of the plastic deformation, to the satisfaction of the metal material (packer, can set and permanent deformation occurs external force, then constitute tight beam blocks can not be plastically deformed, metallic or plastic deformation is small, can not be directly packaged for disposal. such as high carbon steel, tool steel, wire rope and cast iron, etc., can not be directly installed packaged.
Horizontal hydraulic metal baler basic needs:
(1) have a satisfactory kneading force. Metallic material is disposed to make plastic deformation bundle block, and the block is beam must reach the density of demand.
(2) there must be an inclusive metal materials, and can be closed up to accept kneading force bins. In satisfaction of these two basic needs of the premise, but not the same application based on the needs and goals are not the same disposition, it has undergone many different types of metal horizontal hydraulic baler. Horizontal hydraulic metal baler operation principle, that is, the material in a closed box, use the job force pushing the indenter kneading the metal material, the metal material constituting the beam block must scale and density.