factory customized PTFE Packing with Aramid Corner to Finland Factory
factory customized PTFE Packing with Aramid Corner to Finland Factory Detail:
PTFE packing with aramid corner is made from aramid yarns impregnated with PTFE, while the friction faces are made of PTFE yarns. This structure enhances the lubrication ability of aramid fiber and improves the strength of the pure PTFE.
Technical Data Sheet
|
|
Rotating |
Reciprocating |
Valves |
|
Pressure |
4Mpa |
15Mpa |
25Mpa |
|
Shaft Speed |
22m/s rotary |
||
|
Temperature |
-100℃~+280℃ |
||
|
PH Range |
2~12 |
||
Application Area
It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.
Product detail pictures:
Related Product Guide:
What Is A PTFE Ring Gasket?
O-Ring Sizes for Industrial Applications
factory customized PTFE Packing with Aramid Corner to Finland Factory, The product will supply to all over the world, such as: , , ,
Can’t find a replacement for that torn ribbon cable; don’t want to pay for a new one – solder splice the two bits – did you save them ?
PLEASE NOTE: In the making of this video my efforts were necessarily clumsy because I could not take advantage of any magnification directly, especially using the microscope; I had to concentrate on aligning the cam to get a picture, so I was constrained to watching the screen of the VCR, it being too low resolution for productive effort. I would like to have used an eyepiece adaptor that fits both the camcorder and the ‘scope; then I should have been able to peer through the other eyepiece. So be assured it is a great deal easier than I make it look here. I have to admit that relatively few people have access to a stereo microscope; I paid around £180 ( ebay ) for this Russian made Lomo MBC-10, so at least it has been useful apart from being a toy.
I use a Yihua [ goes under several trade names ] workstation that has a heater blower – like a hair drier but hotter and more concentrated flow of air – and a soldering iron that has, as an accessory, a very fine, needle point bit, allowing you to make a good job of such tiny amounts of solder, almost too small to see with the naked eye.
The VX1000 mic/remote/cp flexiboard cable is about 1cm wide; with only a “normal” fine point soldering bit 40 joints were made in the space of approx 0.9 sq cm. The much finer bit was/is available as an optional accessory.
See this video for demonstration of USB microscope: “ToddFun.com: USB Microscope Review”.
Mario Parodi [ Guitar ] plays:-
Albeniz: Rumores de la Caleta; SE-Op 165 – Malaguena
Brahms: Cradle Song Op 49 no 4
Debussy: Arabesca No 1; SB – Clair de lune
By from -
By from -
