China wholesale Carbon Fiber Packing Impregnated with PTFE for Honduras Factory

Diagonal braided to form a dense but pliable packing, each carbon fiber is pre-impregnated with PTFE, and re-impregnated during square braided. It is premium service packing for media of weak chemical corrosion and grains of particles exit.

Technical Data Sheet

 Application Area

Resist all the strong corrosive media and media with a few crystal particles with the exception of the strong oxidizing agent polonium, chiefly used for the sealing of the centrifugal pump, column pump, mixer and valves.

How to remove, clean, and reinstall the throttle body on a 4.2 inline 6 trailblazer.

This procedure is usually done if the engine idles rough or stalls with the a/c or defrost on AFTER the battery has been disconnected.

I also show an alternate method for resetting the pcm. (I found this tip in a post by mwfaith1971 on trailvoy)

Update 3/1/12 – Frequently asked questions:

Q- why do you pull those fuses?
A- to reset the pcm WITHOUT disconnecting the battery

Q- why don’t you disconnect the battery?
A- that could potentially cause hvac actuator failure, moreso in the older ones like my 03…YOU can reset the pcm however you want to in yours:)

Q- can I pull the fuses and then clean the throttle body?
A- absolutely!

Edit 7/2014 – Sorry looks like I have to close comments on this one. Too many peeps trying to promote their shitty channels and giving horrible advice. I’ve probably done this procedure more times then all of you assholes combined so I think I know what the fuck I’m talking about. Thanks for letting me know how much I suck, 169,000 peeps will tell you otherwise.

https://chalkpaintideas.com/1940s-antique-desk-rescued-and-lovingly-transformed-with-chalk-paint/ – Waxing the wood runners and wooden drawers to lubricate them to get drawers unstuck and make them slide easier in an antique desk refurbished with chalk paint. After this desk was painted with Annie Sloan chalk paint, it was time for the finishing touches, including waxing the wooden drawers with wood runners to lubricate them. Here is how I did it!