Factory supplied Serrated Gasket to belarus Factories

1.Structure

Serrated Gasket is made of machined flat metallic plate with waved or corrugated surface in 90 degree angle.

The Serrated Gasket with inner and outer rings or composite gasket attached with flexible graphite or Teflon sheet are available depending on the working location and requirement.

2.Characteristic

Serrated Gasket is an idea gasket used in low pre-tightening, the soft sealing surface avoid metal to metal touch, can be combined reliably and closely, protect flange not to be damaged. This kind of gasket is suitable to high pressure and high temperature location. Strong corrosion resistance, stable and reliable sealing function.

3.Gasket Typ

   Basic Type                                        With outer Ring

4. Working Environment

Working Temperature：~650℃

Working Pressure：6.4-16.0MP

Min. Pre-tightening：y=70MPa

hydraulic compactor main for cardboard
with high pressure power
voltage can be design by require
with CE certificate
The basic principle of horizontal hydraulic metal baler that is the use of metallic materials in the external force, to the nature of the plastic deformation, to the satisfaction of the metal material (packer, can set and permanent deformation occurs external force, then constitute tight beam blocks can not be plastically deformed, metallic or plastic deformation is small, can not be directly packaged for disposal. such as high carbon steel, tool steel, wire rope and cast iron, etc., can not be directly installed packaged.
Horizontal hydraulic metal baler basic needs:
(1) have a satisfactory kneading force. Metallic material is disposed to make plastic deformation bundle block, and the block is beam must reach the density of demand.
(2) there must be an inclusive metal materials, and can be closed up to accept kneading force bins. In satisfaction of these two basic needs of the premise, but not the same application based on the needs and goals are not the same disposition, it has undergone many different types of metal horizontal hydraulic baler. Horizontal hydraulic metal baler operation principle, that is, the material in a closed box, use the job force pushing the indenter kneading the metal material, the metal material constituting the beam block must scale and density.