Massive Selection for Expanded PTFE Tape for Brasilia Manufacturers

Expanded PTFE sealant tape possesses all the properties of PTFE, resistant to all the corrosive media.

Soft, twistable and bendable at will. Even if gravely rusted and worn out sealing face, as long as it is used, the equipment units may continue their service and the sealing can keep its best performance.

Excellent anti-wriggle variation ability and cold current resistance. Even in case of cross change of temperature and pressure, good sealing can be assured.

l Easy use and replacement

l Wide service scope.

Technical Data Sheet

Regular Size

Application Area

It can be widely used in diverse pipelines to seal flanges, enameled products, glass, rubber products, plastics, non-rusting graphite lining tower, heat exchanger, pressure container as linings and to seal their flanges, to seal the fillers of diverse pumps and valves and to seal much heavy-calibre flanges which are not so precise, have larger unflat area and irregular shapes and require not too large tighting force.

After i got done siliconing and painting my box, I figured I’ll make a ‘How to’ video on sealing the gap between the subwoofer and the box. My total cost out of pocket to just seal the gap was less $15 after tax. But prices may vary depending on the hardware store that’s nearest to you.

There was a couple of things I forgot to mention in the video. When you you apply the weather stripping, make sure the surface area is clean and free of any dust. Second, and most important, once you have the mounting hole of the sub lined up with mounting holes, DON’T put a lot of presseure when tightening the screws. Put to much pressure and you’ll push the t-nut out of it’s place. Happened to me twice, hahaha!

So, yeah, just put enough pressure to let the screw tighten. Then once it’s tight, you can torque down the screw tight enough so it won’t come loose.

Thanks for watching my vid, and please rate.

mastagoof