Original Factory Aflas O-Ring Supply to Australia
Original Factory Aflas O-Ring Supply to Australia Detail:
Aflas based synthetic rubber, reinforced with carbon black and peroxide cured. Has good rapid gas decompression(FGD) resistant properties, which making it suitable for many high pressure gas applications. Temperature capability for this type compound is +5~+200℃.
Technical Data Sheet
| Properties | Units | Typical value |
| Hardness | IRHD | 84 |
| Tensile strength | MPa | 22 |
| Elongation at break | % | 189 |
| Modulus at50% elongation | MPa | 4 |
| Modulus at100% elongation | MPa | 12 |
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
A Look at the Molded Gasket
Original Factory Aflas O-Ring Supply to Australia, The product will supply to all over the world, such as: , , ,
-Utilizes special ethylene propylene O-Ring, formulated for steam service
-Flat faced design
-Full flow waterway bore
-Specify prefix letter “S” when ordering…Example: 2″ Fig. S-3131-8-E-304
https://www.classicfilters.com/product/ptfe-membrane-housings/ •
One of our most innovative filtration solutions, Classic Filters’ hydrophobic PTFE membranes and housings are perfectly suited for separating liquid from gas molecules, allowing a pure gas sample to be produced for the protection of analysers and other instruments.
A porous PTFE membrane is supported by a sintered, porous stainless steel disc on the outlet side to increase the strength of the membrane and give a higher differential pressure. Two liquid phases can also be separated if required.
Classic Filters now also offers a new hydrophobic/oleophobic membrane, designed to remove both water and oils from a gas stream.
Permalink: https://youtu.be/Ve6oXIACT4w
By from -
By from -
