Ordinary Discount Spiral Wound Gasket-CGI for Iran Manufacturer
Ordinary Discount Spiral Wound Gasket-CGI for Iran Manufacturer Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
O-Ring Sizes for Industrial Applications
Ordinary Discount Spiral Wound Gasket-CGI for Iran Manufacturer, The product will supply to all over the world, such as: , , ,
First, I sanded the cracked area so the epoxy would adhere to the tank better. After applying the epoxy, I let it cure overnight for 12 hours. However, I noticed a spot that I had missed so I applied more quick steel the following morning.
This is the first time I’ve done this so I’m crossing my fingers hoping it works. I’ve seen other videos where people use soldering irons before applying the epoxy however, I did not take that approach because my tank was full of fuel. I did want to risk catching something on fire.
By from -
By from -
