Cheapest Price Aramid Fiber Braided Packing with PTFE Impregnated to Lithuania Factory
Cheapest Price Aramid Fiber Braided Packing with PTFE Impregnated to Lithuania Factory Detail:
Aramid fiber PTFE packing is braided from high quality Dupont aramid fiber with PTFE impregnated and lubricant additive. This packing can bear higher pressure applications than other types of braided packing. Due to its steel like strength, this yearn can used separately or as back up rings with other types of packing. This packing has been developed to replace asbestos packing for pump systems. It covers all the service ranges which asbestos packing provides and even much better.
Technical Data Sheet
|
Rotating |
Reciprocating |
Valves |
Pressure |
8Mpa |
20Mpa |
30Mpa |
Shaft Speed |
20m/s rotary |
||
Temperature |
-100℃~+280℃ |
||
PH Range |
2~12 |
Application Area
It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.
Product detail pictures:
Related Product Guide:
What Is A PTFE Ring Gasket?
A Look at the Molded Gasket
Cheapest Price Aramid Fiber Braided Packing with PTFE Impregnated to Lithuania Factory, The product will supply to all over the world, such as: , , ,
NOTE: rear shaft seal is not covered in this video – this information can be found online. If you have a deep groove worn into the shaft from this seal, you may have to install the new one in a slightly different position to contact an undamaged part of the shaft to prevent leakage from the backside of the pump.
The MB re-seal kit only includes the front cover o-ring and rear shaft seal – if your pump continues to leak from the front cover after replacement of this while operating, the internal O-rings will be leaking. With time and heat they have all gone hard and brittle now anyway.The internal o-rings have to be sourced from the aftermarket. They are not available as a spare part from MB. They want the whole pump replaced in such case.
Also note, i suggest using something like silcon o-ring grease to allow easy installation of the internal o-rings. Oil on its own may allow the rings to bind and be cut, chipped or shaved, resulting in enormous leaks.
By from -
By from -