100% Original Factory Tellerette Packing Ring to Moscow Factories

Material: PE, PP, RPP, PVC, CPVC and PVDF. Tellerette Packing Rings have features such as high void ratio, low pressure drop, low mass-transfer unit height, high flooding point, uniform gas-liquid contact, small specific weight, high mass transfer efficiency, etc., and the application temperature in media ranges from 60℃ to 150 ℃.For these reasons, them are widely used in the packing towers in petroleum industry, chemical industry, alkali-Chloride industry, coal gas industry and environmental protection, etc.

Technical Data Sheet

I built a physical deposition chamber, for now it’s just evaporative deposition but I plan on adding a few other variants. The thin films created can be used in many ways.
The chamber still has a ton of space leftover and I have some more equipment coming so hopefully I can do more interesting things.
Sorry there’s no footage of lathing the feedthroughs, they worked nice with a cut o-ring and some heat shrink. Make sure you cut a slot down the holding screw threads to vent behind em. The 2 copper feedthroughs allow (with a center tap) 2 tungsten boats with different metals so I can avoid opening the chamber in a multi layer coating.
The pump down takes about 45 min. to get to 10e-5. I can use a small steel hemisphere with a kf40 hose on the top for use with a secondary high vacuum chamber. The shutter was aluminum flashing with some steel stuck on one side so a neodymium magnet on the outside of the bell jar could move it around without a feedthrough.
This build was really fun

I got everything from mcmaster, K.j lesker, ebay and what I already had

This did cost a bit to make:
diffusion pump- $160
mechanical pump-$140
plate- $270 (ouch!)
valves- $90
gauges- $200
misc vacuum stuff -$120
bell jar – $140 (stupid)
other stuff – maybe $100?

I recommend you check out https://www.youtube.com/user/bkraz333
he has done some neat stuff with his setup and a bunch of other things

Warning: Something might be dangerous

Consider supporting me and my projects on patreon! https://www.patreon.com/Bennbuilds