Discountable price Serrated Gasket for Jakarta Manufacturer

1.Structure

Serrated Gasket is made of machined flat metallic plate with waved or corrugated surface in 90 degree angle.

The Serrated Gasket with inner and outer rings or composite gasket attached with flexible graphite or Teflon sheet are available depending on the working location and requirement.

2.Characteristic

Serrated Gasket is an idea gasket used in low pre-tightening, the soft sealing surface avoid metal to metal touch, can be combined reliably and closely, protect flange not to be damaged. This kind of gasket is suitable to high pressure and high temperature location. Strong corrosion resistance, stable and reliable sealing function.

3.Gasket Typ

   Basic Type                                        With outer Ring

4. Working Environment

Working Temperature：~650℃

Working Pressure：6.4-16.0MP

Min. Pre-tightening：y=70MPa

How to remove, clean, and reinstall the throttle body on a 4.2 inline 6 trailblazer.

This procedure is usually done if the engine idles rough or stalls with the a/c or defrost on AFTER the battery has been disconnected.

I also show an alternate method for resetting the pcm. (I found this tip in a post by mwfaith1971 on trailvoy)

Update 3/1/12 – Frequently asked questions:

Q- why do you pull those fuses?
A- to reset the pcm WITHOUT disconnecting the battery

Q- why don’t you disconnect the battery?
A- that could potentially cause hvac actuator failure, moreso in the older ones like my 03…YOU can reset the pcm however you want to in yours:)

Q- can I pull the fuses and then clean the throttle body?
A- absolutely!

Edit 7/2014 – Sorry looks like I have to close comments on this one. Too many peeps trying to promote their shitty channels and giving horrible advice. I’ve probably done this procedure more times then all of you assholes combined so I think I know what the fuck I’m talking about. Thanks for letting me know how much I suck, 169,000 peeps will tell you otherwise.