professional factory provide IMPAC Ring for Ireland Factory

IMPAC RING is our new developed tower packing replacing Pall ring and other random tower packings. Compared with pall ring, IMPAC Ring has better compare surface area, and also can be working longer.

Material: Carbon Steel, SS304, SS304L, SS316, SS316L

Technical Data Sheet

NOTE: rear shaft seal is not covered in this video – this information can be found online. If you have a deep groove worn into the shaft from this seal, you may have to install the new one in a slightly different position to contact an undamaged part of the shaft to prevent leakage from the backside of the pump.

The MB re-seal kit only includes the front cover o-ring and rear shaft seal – if your pump continues to leak from the front cover after replacement of this while operating, the internal O-rings will be leaking. With time and heat they have all gone hard and brittle now anyway.The internal o-rings have to be sourced from the aftermarket. They are not available as a spare part from MB. They want the whole pump replaced in such case.

Also note, i suggest using something like silcon o-ring grease to allow easy installation of the internal o-rings. Oil on its own may allow the rings to bind and be cut, chipped or shaved, resulting in enormous leaks.

The aim of tightening a compression joint is to create a gas tight joint without compressing the olive too tight on the pipe by over tightening the nut as this will restrict flow through the pipe as the pipe will have been made internally smaller.

GAS IT and FES Autogas Ltd do not accept any liability from users following this video or information we provide.

We highly recommend getting a GAS IT Trained Dealer or Qualified Gas engineer to check your installation and fitment of GAS IT parts prior to filling and using it with LPG/ Autogas.