2017 China New Design PTFE Packing with Aramid Corner to Czech Republic Factory
2017 China New Design PTFE Packing with Aramid Corner to Czech Republic Factory Detail:
PTFE packing with aramid corner is made from aramid yarns impregnated with PTFE, while the friction faces are made of PTFE yarns. This structure enhances the lubrication ability of aramid fiber and improves the strength of the pure PTFE.
Technical Data Sheet
|
Rotating |
Reciprocating |
Valves |
Pressure |
4Mpa |
15Mpa |
25Mpa |
Shaft Speed |
22m/s rotary |
||
Temperature |
-100℃~+280℃ |
||
PH Range |
2~12 |
Application Area
It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
Comparison of O-Ring Materials
2017 China New Design PTFE Packing with Aramid Corner to Czech Republic Factory, The product will supply to all over the world, such as: , , ,
Have you been fighting a mystery creak, chirp, or other bizarre noise that can’t be tracked down? Watch BikeCo’s Joe Binatena go through the steps of correcting bearing interface. Take Joe’s advice and check the easy stuff first – but if you are still struggling to find the cause of your noise these steps may save you a lot of heartache, hours of searching, and potential damage on your frame.
This is the first in a series of videos touching on locating and theories on addressing mystery creaks.
By from -
By from -