High Quality Industrial Factory Spiral Wound Gasket-RIR for Portugal Importers
High Quality Industrial Factory Spiral Wound Gasket-RIR for Portugal Importers Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
What Is A PTFE Ring Gasket?
High Quality Industrial Factory Spiral Wound Gasket-RIR for Portugal Importers, The product will supply to all over the world, such as: , , ,
Hinged Pipe Repair Clamp S size 290.0mm to suit the outside diameter pipe of 290mm. The hinged pipe repair clamp by ORBIT COUPLINGS in Australia is manufactured from 316 stainless steel with teflon coated stainless steel bolts. EPDM Sleeve/ Seal rated to 16 Bar / PN16 / 1600 KPa. The hinged repair clamp is an easy and simple to install pipe repair clamp which opens on a hinge, allowing the clamp to fully open and wrap around the pipe that you are wanting to repair. Simply fit the clamp over the crack or hole in the pipe, and tighten the bolts to the torque stated on the pipe clamp. The hinged repair clamp is available in sizes up to 350mm nominal bore. Above size 350mm then we recommend the Double Lock Clamp by ORBIT COUPLINGS.
For more information on pipe couplings and pipe repair clamps in Australia visit https://orbitcouplings.com.au/
By from -
By from -
