High quality factory PTFE Graphite Braided Packing for Lahore Factories

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming sulfuric acid,etc.) for centrifugal pumps, autoclaes, agitators mixers, etc.

Technical Data Sheet

 Application Area

It can be used to seal alkalis, solvents, water, steam, for centrifugal pumps, autoclaves, agitators, mixers, etc.

WidgetWorks Hobby Vacuum Formers and Thermoform Plastic Sheets are perfect for inventors, small businesses, and DIY hobbyists who want to make custom vacuum formed plastic parts. Use our Hobby Vacuum Formers and Thermoform Plastic Sheets along with your kitchen oven and a Shop-Vac vacuum cleaner to thermoform homemade plastic parts with results that rival expensive commercial machines. Make your own plastic prototypes, clamshell and blister packaging, custom molds, scale model parts, and movie props.

Hobby Vacuum Formers and Thermoform Plastic Sheets are available through our website:
www.WidgetWorksUnlimited.com

HOW TO VACUUM FORM IN 3 EASY STEPS

STEP 1: Secure your thermoform plastic between the Hobby Vacuum Former’s metal clamping frames with the provided spring clips. Attach your Shop-Vac (not included) to the vacuum former. Place your model on top of the vacuum formers perforated aluminum platen.

STEP 2: Place the thermoform plastic in your kitchen oven and watch as it begins to sag. When the plastic becomes soft, remove it from the oven. Align the metal clamping frames with the Hobby Vacuum Former’s guides and lower the plastic over your model.

STEP 3: The hot thermoform plastic forms an air tight seal around the edges of the aluminum vacuum platen. Vacuum pressure pulls the hot plastic down around the model. After cooling for a few seconds the thermoform plastic part hardens and is ready to be removed.