OEM/ODM China Spiral Wound Gasket-CGI for Mongolia Importers
OEM/ODM China Spiral Wound Gasket-CGI for Mongolia Importers Detail:
Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.
Feature
Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.
Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface
Easy installation and handy use.
Excellent Sealability
Products Type
Technical Data Sheet
|
Product&Type |
Size（mm） |
Temperature(℃) |
Pressure（Mpa） |
|
Spiral Wound Gasket filled with Graphite
|
φ16~φ3200 |
(In Oxidizing Environment )-240~+550℃；(In non-Oxidizing Environment)-240~+870℃ |
(Under hot water, oil etc. )30 Mpa; (Under vapor oil, gases etc.)20 Mpa |
|
Spiral Wound Gasket filled with Asbestos
|
φ16~φ3200 |
-150~+450℃ |
15 |
|
Spiral Wound Gasket filled with PTFE
|
φ16~φ3200 |
-200~+250℃ |
15 |
Application Area
The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.
Product detail pictures:
Related Product Guide:
Useful Tips For Installing The Teflon Envelope Gasket
A Look at the Molded Gasket
OEM/ODM China Spiral Wound Gasket-CGI for Mongolia Importers, The product will supply to all over the world, such as: , , ,
Demonstration of shrinking size reducing urethane casting resin Hydrospan 400 is manufactured by Industrial Polymers Corporation USA. www.industrialpolymers.com 713-943-8451 800-766-3832. Direct USA manufacturer of a complete line of flexible mold making rubbers and rigid casting resins and shrinking and expanding resins. HydroSpan 400, when fully cured provides for simple method for reducing three dimensionally molded parts. Reduction of parts is done by simply molding the part with HydroSpan 400 to form a rubber master. Visit our web site or call us to place an order. https://industrialpolymers.com/hydrospan/hydrospan-400
This is a video preview for one of many online courses for continuing education credit we offer at www.handlab.com
This 1.5 hour lecture with demonstration video of orthosis construction steps allows you to solve the challenge of making an orthosis to stabilize all MP joints in extension while allowing full IP joint flexion. Learn a systematic approach to pattern making, positioning, and molding to construct an effective orthosis which elongates both the interosseous and lumbrical muscles. This course is the last part of six lectures that are intended to be viewed in sequence.
By from -
By from -
