2017 China New Design PTFE Packing with Aramid Corner for Iceland Manufacturers
2017 China New Design PTFE Packing with Aramid Corner for Iceland Manufacturers Detail:
PTFE packing with aramid corner is made from aramid yarns impregnated with PTFE, while the friction faces are made of PTFE yarns. This structure enhances the lubrication ability of aramid fiber and improves the strength of the pure PTFE.
Technical Data Sheet
|
|
Rotating |
Reciprocating |
Valves |
|
Pressure |
4Mpa |
15Mpa |
25Mpa |
|
Shaft Speed |
22m/s rotary |
||
|
Temperature |
-100℃~+280℃ |
||
|
PH Range |
2~12 |
||
Application Area
It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.
Product detail pictures:
Related Product Guide:
What Is A PTFE Ring Gasket?
A Look at the Molded Gasket
2017 China New Design PTFE Packing with Aramid Corner for Iceland Manufacturers, The product will supply to all over the world, such as: , , ,
Re-install the drive shaft and jet pump.
Clean threads inside the bolt holes in the pump base and clean the bolt threads.
Grease the splines on both ends of the drive shaft, and the O-ring seal that fits into the impeller.
Make sure the pump section fully seats aginst the pump base, and the drive shaft fully engages the PTO drive coupler.
As you tighten the bolts, check that the nozzle assembly is square and level, not tilted. Snug the bolts, check for proper pump assembly.
Then torque to 18 ft-lbs in a criss-cross pattern.
By from -
By from -
