Factory Wholesale PriceList for FEP Encapsulated O-Ring Export to Holland
Factory Wholesale PriceList for FEP Encapsulated O-Ring Export to Holland Detail:
Encapsulated O Ring adopts special rubber resisting high temperature, F+ plastic and special engineering to compound this sealing product. It not only has low contraction permanent set functions of rubber O Ring, but also resistant heat, cold oil, friction, chemical corrusion and other performances. It can be used in all kind of dynamical seal and static seal widely, meanwhile can replace all traditional rubber and plastic O Ring.
Technical Data Sheet
Property |
Unit |
Result |
|||
A |
B |
C |
|||
Normal Conditions |
Hardness |
JIS Hs |
70~90 |
70~90 |
60~75 |
Elongations(min.) |
% |
60 |
60 |
80 |
|
Tensile Stress(min) |
Mpa |
16 |
16 |
16 |
|
Compressibility |
% |
50~60 |
50~60 |
60~75 |
|
Recovery |
% |
>85 |
>85 |
>70 |
|
Permanentset |
% |
<10 |
<10 |
<10 |
|
230°Cx24h hot air ageing |
Change of hardness(max) |
JIS Hs |
-5~+5 |
-5~+5 |
-5~+5 |
Change of Tensile Stress(max) |
% |
-15 |
-15 |
-15 |
|
Change of Elongation(max) |
% |
-20 |
-20 |
-20 |
|
Compression Permanentset |
175°Cx70h |
% |
≤20 |
≤20 |
≤20 |
Color |
|
|
Brown |
Black |
Red |
Applications |
Temperature Limited |
℃ |
-20~+250 |
-20~+200 |
-20~+200 |
Pressure Limited |
Mpa |
0~35 |
|||
Working Environment |
|
Strong Caustics, moderate acids, chlorine, gases, water, steam, hydrocarbons, hydrogen and aluminum fluoride except element fluorine and fusion sodium. |
Product detail pictures:
Related Product Guide:
Comparison of O-Ring Materials
What Is A PTFE Ring Gasket?
Factory Wholesale PriceList for FEP Encapsulated O-Ring Export to Holland, The product will supply to all over the world, such as: , , ,
How to remove, clean, and reinstall the throttle body on a 4.2 inline 6 trailblazer.
This procedure is usually done if the engine idles rough or stalls with the a/c or defrost on AFTER the battery has been disconnected.
I also show an alternate method for resetting the pcm. (I found this tip in a post by mwfaith1971 on trailvoy)
Update 3/1/12 – Frequently asked questions:
Q- why do you pull those fuses?
A- to reset the pcm WITHOUT disconnecting the battery
Q- why don’t you disconnect the battery?
A- that could potentially cause hvac actuator failure, moreso in the older ones like my 03…YOU can reset the pcm however you want to in yours:)
Q- can I pull the fuses and then clean the throttle body?
A- absolutely!
Edit 7/2014 – Sorry looks like I have to close comments on this one. Too many peeps trying to promote their shitty channels and giving horrible advice. I’ve probably done this procedure more times then all of you assholes combined so I think I know what the fuck I’m talking about. Thanks for letting me know how much I suck, 169,000 peeps will tell you otherwise.
By from -
By from -