factory wholesale good quality Ramie Braided Packing for Iraq Manufacturers

Short Description:

Ramie packing is braided from natural ramie impregnated with PTFE emulsion, ramie has higher structural strength and turns soft in the water. The PTFE emulsion enhances the lubrication ability of ramie.  Technical Data Sheet   Rotating Reciprocating Valves Pressure 2Mpa 2Mpa 3Mpa Shaft Speed 8m/s rotary Temperature -50℃~+130℃ PH Range 5~11


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
factory wholesale good quality Ramie Braided Packing for Iraq Manufacturers Detail:

Ramie packing is braided from natural ramie impregnated with PTFE emulsion, ramie has higher structural strength and turns soft in the water. The PTFE emulsion enhances the lubrication ability of ramie.

 Technical Data Sheet

 

Rotating

Reciprocating

Valves

Pressure

2Mpa

2Mpa

3Mpa

Shaft Speed

8m/s rotary

Temperature

-50℃~+130℃

PH Range

5~11


Product detail pictures:

factory wholesale good quality
 Ramie Braided Packing for Iraq Manufacturers detail pictures


Related Product Guide:
Comparison of O-Ring Materials
What Is A PTFE Ring Gasket?

factory wholesale good quality Ramie Braided Packing for Iraq Manufacturers, The product will supply to all over the world, such as: , , ,


  • NOTE: rear shaft seal is not covered in this video – this information can be found online. If you have a deep groove worn into the shaft from this seal, you may have to install the new one in a slightly different position to contact an undamaged part of the shaft to prevent leakage from the backside of the pump.

    The MB re-seal kit only includes the front cover o-ring and rear shaft seal – if your pump continues to leak from the front cover after replacement of this while operating, the internal O-rings will be leaking. With time and heat they have all gone hard and brittle now anyway.The internal o-rings have to be sourced from the aftermarket. They are not available as a spare part from MB. They want the whole pump replaced in such case.

    Also note, i suggest using something like silcon o-ring grease to allow easy installation of the internal o-rings. Oil on its own may allow the rings to bind and be cut, chipped or shaved, resulting in enormous leaks.


    5 Stars By from -

    5 Stars By from -

    Related Products