Excellent quality for PTFE Graphite Braided Packing to Suriname Importers

Short Description:

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming ...


Product Detail

Product Tags

Related Video

Feedback (2)

, , ,
Excellent quality for PTFE Graphite Braided Packing to Suriname Importers Detail:

It is a braided packing made of PTFE yarn containing graphite. It is recommended for shafts for almost all chemicals. Stability and long service lift are achieved by low friction coefficient. It has great tear strength and high thermal conductivity. This self lubrication packing does not score the shaft and minimizes sleeve rep, acement cost. It can be used to seal alkalis, solvents, water, steam, acids except strong oxidizing acids( aqua regia, fuming nitric acid, fuming nitric acid, fuming sulfuric acid,etc.) for centrifugal pumps, autoclaes, agitators mixers, etc.

Technical Data Sheet

 

Rotating

Reciprocating

Valves

Pressure

2Mpa

15Mpa

15Mpa

Shaft Speed

14m/s rotary

Temperature

-200℃~+280℃

PH Range

0~14

 Application Area

It can be used to seal alkalis, solvents, water, steam, for centrifugal pumps, autoclaves, agitators, mixers, etc.


Product detail pictures:

Excellent quality for
 PTFE Graphite Braided Packing to Suriname Importers detail pictures


Related Product Guide:
Useful Tips For Installing The Teflon Envelope Gasket
What Is A PTFE Ring Gasket?

Excellent quality for PTFE Graphite Braided Packing to Suriname Importers, The product will supply to all over the world, such as: , , ,


  • Can’t find a replacement for that torn ribbon cable; don’t want to pay for a new one – solder splice the two bits – did you save them ?

    PLEASE NOTE: In the making of this video my efforts were necessarily clumsy because I could not take advantage of any magnification directly, especially using the microscope; I had to concentrate on aligning the cam to get a picture, so I was constrained to watching the screen of the VCR, it being too low resolution for productive effort. I would like to have used an eyepiece adaptor that fits both the camcorder and the ‘scope; then I should have been able to peer through the other eyepiece. So be assured it is a great deal easier than I make it look here. I have to admit that relatively few people have access to a stereo microscope; I paid around £180 ( ebay ) for this Russian made Lomo MBC-10, so at least it has been useful apart from being a toy.

    I use a Yihua [ goes under several trade names ] workstation that has a heater blower – like a hair drier but hotter and more concentrated flow of air – and a soldering iron that has, as an accessory, a very fine, needle point bit, allowing you to make a good job of such tiny amounts of solder, almost too small to see with the naked eye.

    The VX1000 mic/remote/cp flexiboard cable is about 1cm wide; with only a “normal” fine point soldering bit 40 joints were made in the space of approx 0.9 sq cm. The much finer bit was/is available as an optional accessory.

    See this video for demonstration of USB microscope: “ToddFun.com: USB Microscope Review”.

    Mario Parodi [ Guitar ] plays:-

    Albeniz: Rumores de la Caleta; SE-Op 165 – Malaguena
    Brahms: Cradle Song Op 49 no 4
    Debussy: Arabesca No 1; SB – Clair de lune


    5 Stars By from -

    5 Stars By from -

    Related Products