Factory selling Spiral Wound Gasket-R for Argentina Manufacturer

Spiral wound gasket consists of “V-shape”(or”W-shape”)metal tape and nonmetal tape, which are overlapped each other and wound continuously.To fasten the metal tape,both its start point and end point are tack welded.

Feature

Wide Scope of acceptable working conditions. Can be used under high temperature, high pressure and ultra-low temperature or vacuum conditions. Change the combination of the gasket materials is to tackle the chemical corrosion problem of diverse media toward the gasket.

Not very rigid requirements to the surface precision of the flange. May be used to seal flanges with rough surface

Easy installation and handy use.

Excellent Sealability

Products Type

echnical Data Sheet

 Application Area

The Spiral Wound Gaskets are mainly used in valves &pipes, pressure vessel, condenser, heat exchanger flanges in oil, chemical, metallurgy, vessel and mechanical industries.

How to remove, clean, and reinstall the throttle body on a 4.2 inline 6 trailblazer.

This procedure is usually done if the engine idles rough or stalls with the a/c or defrost on AFTER the battery has been disconnected.

I also show an alternate method for resetting the pcm. (I found this tip in a post by mwfaith1971 on trailvoy)

Update 3/1/12 – Frequently asked questions:

Q- why do you pull those fuses?
A- to reset the pcm WITHOUT disconnecting the battery

Q- why don’t you disconnect the battery?
A- that could potentially cause hvac actuator failure, moreso in the older ones like my 03…YOU can reset the pcm however you want to in yours:)

Q- can I pull the fuses and then clean the throttle body?
A- absolutely!

Edit 7/2014 – Sorry looks like I have to close comments on this one. Too many peeps trying to promote their shitty channels and giving horrible advice. I’ve probably done this procedure more times then all of you assholes combined so I think I know what the fuck I’m talking about. Thanks for letting me know how much I suck, 169,000 peeps will tell you otherwise.

Visit https://parts.rheem.com to buy manufacturer authorized parts for Rheem, Ruud, Richmond, Marathon, Eclipse, Vanguard, Hotpoint and General Electric (GE) water heaters. We also offer many universal parts designed to fit most other brands of water heaters.

If your water heater’s drain valve is leaking, or doesn’t allow a good water flow while flushing the tank, it’s time to replace the valve. This is a relatively easy job you can do yourself in about 30 minutes.

This video shows detailed step-by-step procedure for how to replace a drain valve on a gas or electric hot water heater.

Tools you’ll need
Replacement drain valve
Adjustable wrench
Pipe sealer or Teflon tape
Rags or towels

WARNING: For your safety, be sure to carefully read and understand the manufacturer’s Use and Care Manual, in its entirety, prior to operating, repairing or adjusting the water heater. Failure to do so may result in fire or explosion, electric shock, property damage, personal injury, or loss of life. If you do not understand these instruction or any terms within them, please contact a qualified service professional. Prior to starting any repairs or service on your water heater, please thoroughly read the Use and Care Manual provided with your water heater. If at any time you are unsure or uncomfortable about the suggested repair or service discussed herein, stop any activity and immediately contact a licensed plumber.