Factory Cheap FEP Encapsulated O-Ring to Rome Factories

Short Description:

Encapsulated O Ring adopts special rubber resisting high temperature, F+ plastic and special engineering to compound this sealing product. It not only has low contraction permanent set functions of rubber O Ring, but also resistant heat, cold oil, friction, chemical corrusion and other performances. It can be used in all kind of dynamical seal and static seal widely, meanwhile can replace all traditional rubber and plastic O Ring. Technical Data Sheet Property Unit Result A B ...

Send email to us Download as PDF

Product Detail

Product Tags

Feedback (2)

, , ,

Factory Cheap FEP Encapsulated O-Ring to Rome Factories Detail:

Technical Data Sheet

Property		Unit	Result
Property		Unit	A	B	C
Normal Conditions	Hardness	JIS Hs	70~90	70~90	60~75
	Elongations(min.)	%	60	60	80
	Tensile Stress(min)	Mpa	16	16	16
	Compressibility	%	50~60	50~60	60~75
	Recovery	%	＞85	＞85	＞70
	Permanentset	%	＜10	＜10	＜10
230°Cx24h hot air ageing	Change of hardness(max)	JIS Hs	-5~+5	-5~+5	-5~+5
	Change of Tensile Stress(max)	%	-15	-15	-15
	Change of Elongation(max)	%	-20	-20	-20
Compression Permanentset	175°Cx70h	%	≤20	≤20	≤20
Color			Brown	Black	Red
Applications	Temperature Limited	℃	-20~+250	-20~+200	-20~+200
	Pressure Limited	Mpa	0~35
	Working Environment		Strong Caustics, moderate acids, chlorine, gases, water, steam, hydrocarbons, hydrogen and aluminum fluoride except element fluorine and fusion sodium.

Product detail pictures:

Factory Cheap FEP Encapsulated O-Ring to Rome Factories, The product will supply to all over the world, such as: , , ,

Fep Encapsulated O Rings for India

Fep Encapsulated Viton O Ring to Portugal

O Rings wholesale

Ptfe Gasket Tape

Ptfe Tape Gas Cooker

Pump Packing Mechanical Seal

NOTE: rear shaft seal is not covered in this video – this information can be found online. If you have a deep groove worn into the shaft from this seal, you may have to install the new one in a slightly different position to contact an undamaged part of the shaft to prevent leakage from the backside of the pump.

The MB re-seal kit only includes the front cover o-ring and rear shaft seal – if your pump continues to leak from the front cover after replacement of this while operating, the internal O-rings will be leaking. With time and heat they have all gone hard and brittle now anyway.The internal o-rings have to be sourced from the aftermarket. They are not available as a spare part from MB. They want the whole pump replaced in such case.

Also note, i suggest using something like silcon o-ring grease to allow easy installation of the internal o-rings. Oil on its own may allow the rings to bind and be cut, chipped or shaved, resulting in enormous leaks.