100% Original Factory Tellerette Packing Ring to Moscow Factories
100% Original Factory Tellerette Packing Ring to Moscow Factories Detail:
Material: PE, PP, RPP, PVC, CPVC and PVDF. Tellerette Packing Rings have features such as high void ratio, low pressure drop, low mass-transfer unit height, high flooding point, uniform gas-liquid contact, small specific weight, high mass transfer efficiency, etc., and the application temperature in media ranges from 60℃ to 150 ℃.For these reasons, them are widely used in the packing towers in petroleum industry, chemical industry, alkali-Chloride industry, coal gas industry and environmental protection, etc.
Technical Data Sheet
Product detail pictures:
Related Product Guide:
What Is A PTFE Ring Gasket?
A Look at the Molded Gasket
100% Original Factory Tellerette Packing Ring to Moscow Factories, The product will supply to all over the world, such as: , , ,
Using Teflon Tape.
WidgetWorks Hobby Vacuum Formers and Thermoform Plastic Sheets are perfect for inventors, small businesses, and DIY hobbyists who want to make custom vacuum formed plastic parts. Use our Hobby Vacuum Formers and Thermoform Plastic Sheets along with your kitchen oven and a Shop-Vac vacuum cleaner to thermoform homemade plastic parts with results that rival expensive commercial machines. Make your own plastic prototypes, clamshell and blister packaging, custom molds, scale model parts, and movie props.
Hobby Vacuum Formers and Thermoform Plastic Sheets are available through our website:
www.WidgetWorksUnlimited.com
HOW TO VACUUM FORM IN 3 EASY STEPS
STEP 1: Secure your thermoform plastic between the Hobby Vacuum Former’s metal clamping frames with the provided spring clips. Attach your Shop-Vac (not included) to the vacuum former. Place your model on top of the vacuum formers perforated aluminum platen.
STEP 2: Place the thermoform plastic in your kitchen oven and watch as it begins to sag. When the plastic becomes soft, remove it from the oven. Align the metal clamping frames with the Hobby Vacuum Former’s guides and lower the plastic over your model.
STEP 3: The hot thermoform plastic forms an air tight seal around the edges of the aluminum vacuum platen. Vacuum pressure pulls the hot plastic down around the model. After cooling for a few seconds the thermoform plastic part hardens and is ready to be removed.
By from -
By from -