8 Years Manufacturer Rubber Gasket/Washer to Pakistan Factories

Rubber is the most cost-effective material to use where temperature and pressures are low and the chemical environment is mild. Different elastomers offer different mechanical and chemical properties. Cloth&metal inserted materials are better able to handle movement and high compression loads.

Technical Data Sheet

Application Area

l Electron Components

l Medical Equipment

l Home Appliance

l Mechanical Equipment

l Office Facilities

l Aviation

l Construction

l Automobile

This is an example of how craftspeople at Gaskets, Incorporated manufacture custom designed tadpole seals. The seal being sewn in this video has a PTFE coated fiberglass cover with an Inconel® Steel solid mesh core. The design is a type 8 and will be used as a seal between an insulated locker and door for extra low temperature cryogenic processing. Our PTFE seals can be used in applications as cold as -450° F/-267° C.

In this video I cover repairing both internal and external oil leaks on 1994-1997 Honda 4 cylinder engine distributors.

Many state if the distributor is leaking internally it can’t be repaired and to buy a new distributor. Well with the right part number and a bit of patience. You can fix that internal oil leak and save yourself at least 180 bucks.

I also address repairing the common outer seal leak as well.

Here are the part numbers you’ll need. There are different part numbers depending on which distributor you have.

You either have a Tec distributor with an external ignition coil or a Hitachi distributor with an internal ignition coil. The Tec distributor caps have 5 wires on them while the Hitachi’s have 4 wires on their cap.

The Hitachi distributors require a bit more internal disassembly but the seal replacement process is identical to the Tec shown in the video.

Tec Part Numbers:

Outer O-Ring Seal: 30110-PA1-732 (From Honda).

Inner Shaft Seal Part Number: NOK BH3888E (Order Online). The dimensions of this seal are 12.5 X 22.5 X 5mm.

Hitachi part numbers:

Outer O-Ring Seal: 30110-PC6-005 (From Honda).

Inner Shaft Seal Part Number: KOK 3286 (Order Online). The dimensions of this seal are 12.45mm X 22mm X 6mm.

If you replace your heater core inlet hose you’ll need to bleed the cooling system.

Here is a link to my video on bleeding the cooling system:

https://www.youtube.com/watch?v=owQcxSrKARA

Intro and outro music Hot Swing by Kevin Macleod (Incompetech.com).

Due to factors beyond the control of Bushougoma, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Bushougoma assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Bushougoma recommends safe practices when working with the tools or equipment seen or implied in this video. No information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Bushougoma.