11 Years Manufacturer Carbon Fiber Packing Impregnated with PTFE to Norway Factories
11 Years Manufacturer Carbon Fiber Packing Impregnated with PTFE to Norway Factories Detail:
Diagonal braided to form a dense but pliable packing, each carbon fiber is pre-impregnated with PTFE, and re-impregnated during square braided. It is premium service packing for media of weak chemical corrosion and grains of particles exit.
Technical Data Sheet
|
Rotating |
Reciprocating |
Valves |
Pressure |
3Mpa |
10Mpa |
25Mpa |
Shaft Speed |
15m/s rotary |
||
Temperature |
-200℃~+280℃ |
||
PH Range |
2~12 |
Application Area
Resist all the strong corrosive media and media with a few crystal particles with the exception of the strong oxidizing agent polonium, chiefly used for the sealing of the centrifugal pump, column pump, mixer and valves.
Product detail pictures:
Related Product Guide:
A Look at the Molded Gasket
Comparison of O-Ring Materials
11 Years Manufacturer Carbon Fiber Packing Impregnated with PTFE to Norway Factories, The product will supply to all over the world, such as: , , ,
A&M HW100 fill valve leak repair.
If you have a leaky cylinder you should contact A&M, who should repair it under warranty.
If you find your A&M cylinder is leaking from the fill port then you can either replace the O ring on the little plunger inside the valve or you can convert it to a simple M10* countersunk bolt with an O ring seal. The O rings and bolts can be bought on eBay or your local DIY store.
*It has come to my attention that A&M use a number of different sizes of bolts in their fill valves so you will need to measure yours to make sure you are buying the correct size bolt and O ring.
www.xtxair.com
If you have a leaky cylinder you should contact A&M, who should repair it under warranty.
By from -
By from -