Factory selling Die Formed Graphite Ring Export to Iraq

Die formed graphite packing ring is made of pure flexible graphite ,or Graphite with inconel /SS316/Brass wire reinforced.

 Performance and Features

• Perfect self lubricant performance.        
• High elasticity coefficiency.
• Scope of Application

Working temperature:~200~400℃(200~800℃ under non-oxidation atmosphere)

Working pressure:≤35MPa

Density:1.4 ~ 1.6 g/cm3

hydraulic compactor main for cardboard
with high pressure power
voltage can be design by require
with CE certificate
The basic principle of horizontal hydraulic metal baler that is the use of metallic materials in the external force, to the nature of the plastic deformation, to the satisfaction of the metal material (packer, can set and permanent deformation occurs external force, then constitute tight beam blocks can not be plastically deformed, metallic or plastic deformation is small, can not be directly packaged for disposal. such as high carbon steel, tool steel, wire rope and cast iron, etc., can not be directly installed packaged.
Horizontal hydraulic metal baler basic needs:
(1) have a satisfactory kneading force. Metallic material is disposed to make plastic deformation bundle block, and the block is beam must reach the density of demand.
(2) there must be an inclusive metal materials, and can be closed up to accept kneading force bins. In satisfaction of these two basic needs of the premise, but not the same application based on the needs and goals are not the same disposition, it has undergone many different types of metal horizontal hydraulic baler. Horizontal hydraulic metal baler operation principle, that is, the material in a closed box, use the job force pushing the indenter kneading the metal material, the metal material constituting the beam block must scale and density.

NOTE: rear shaft seal is not covered in this video – this information can be found online. If you have a deep groove worn into the shaft from this seal, you may have to install the new one in a slightly different position to contact an undamaged part of the shaft to prevent leakage from the backside of the pump.

The MB re-seal kit only includes the front cover o-ring and rear shaft seal – if your pump continues to leak from the front cover after replacement of this while operating, the internal O-rings will be leaking. With time and heat they have all gone hard and brittle now anyway.The internal o-rings have to be sourced from the aftermarket. They are not available as a spare part from MB. They want the whole pump replaced in such case.

Also note, i suggest using something like silcon o-ring grease to allow easy installation of the internal o-rings. Oil on its own may allow the rings to bind and be cut, chipped or shaved, resulting in enormous leaks.