12 Years Factory wholesale PTFE Graphite Packing with Aramid Corner to Belgium Manufacturers

PTFE graphite packing with aramid corner is made from aramid yarns impregnated with PTFE, while the friction faces are made of graphite PTFE yarns. The graphite particle in PTFE yarn enhances the heat exchange efficiency.

Technical Data Sheet

 Application Area

It affords longer service life under severe conditions which conventional asbestos packing can bot provide satisfaction, such as mine, tin ore, paper pulp, feed water pump of power stations, etc.

After i got done siliconing and painting my box, I figured I’ll make a ‘How to’ video on sealing the gap between the subwoofer and the box. My total cost out of pocket to just seal the gap was less $15 after tax. But prices may vary depending on the hardware store that’s nearest to you.

There was a couple of things I forgot to mention in the video. When you you apply the weather stripping, make sure the surface area is clean and free of any dust. Second, and most important, once you have the mounting hole of the sub lined up with mounting holes, DON’T put a lot of presseure when tightening the screws. Put to much pressure and you’ll push the t-nut out of it’s place. Happened to me twice, hahaha!

So, yeah, just put enough pressure to let the screw tighten. Then once it’s tight, you can torque down the screw tight enough so it won’t come loose.

Thanks for watching my vid, and please rate.

mastagoof